Emergency line open 24/7 · Times shown in ET

Heating repair in Knoxville, TN

Knoxville sits in Knox County and we cover 31 ZIP codes across it. Furnace, boiler and heat pump faults route to an independent local provider.

Your call connects you with an independent local HVAC provider. No obligation.

Call (855) 321-3194

Answer

How do I get heating repair in Knoxville, TN today?

Call (855) 321-3194 for no-heat calls across Knoxville, TN. We connect you with an independent local provider. They confirm when they can reach you and quote the repair before starting it.

Heating calls in Knoxville

Heating failures in Knoxville are more time-sensitive than cooling faults, because a house loses temperature faster than it gains it. We cover 31 ZIP codes across Knox County for furnace, boiler and heat pump faults.

The grid covers 31 Knoxville ZIP codes. Each one routes to independent providers handling furnaces, boilers and heat pumps across Knox County.

Local considerations

Older Knoxville housing stock often runs boilers rather than forced air, which changes the fault list to pressure, circulators and zone valves. Mention the system type when you call so the right provider is matched.

Combustion appliances in Knoxville require adequate fresh air for safe operation. Sealed homes with modern insulation can starve a furnace of combustion air, which shows up as cycling or incomplete combustion rather than a dramatic failure.

Looking for the other side of the system? AC Repair in Knoxville, TN.

CityKnoxville

CountyKnox

StateTennessee

ZIPs covered31

Other vertical

AC Repair in Knoxville, TN

Services

Heating services in Knoxville

Below are the heating jobs Knoxville providers see most, across furnaces, boilers, heat pumps and the controls that run them.

6 services

Furnace Repair in Knoxville

Three ignition attempts followed by a lockout is the furnace telling you the flame sensor needs cleaning or the igniter is close to failure.

View furnace repair

Furnace Installation and Replacement service

Furnace Installation and Replacement in Knoxville

Frequent lockouts on an older furnace mean escalating repair costs toward a number that makes replacement the more sensible use of the money.

Details

Heat Pump Repair in Knoxville

A heat pump that runs constantly without warming the house is usually leaning on auxiliary resistance because the compressor side is not contributing.

Details

Boiler Repair in Knoxville

A boiler losing pressure in midwinter risks frozen pipes as well as cold rooms, so it moves to the front of the queue.

Details

Thermostat Installation and Repair service

Thermostat Installation and Repair in Knoxville

Short cycling in heating mode stresses the heat exchanger through repeated thermal shock, making thermostat problems worth addressing promptly.

Details

HVAC Maintenance and Tune-Up in Knoxville

Heat exchanger inspection during a tune-up is the one check that cannot wait until a fault appears, because cracks create carbon monoxide risk before the system stops heating.

Details

Interactive

What is your thermostat reading?

Drag the dial to the temperature your thermostat shows now. The readout names the likely cause band, how urgent it is, and which page to read next.

Degrees F

Indoor temperature

Likely cause band: Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.
Urgency: Call today
Read next: AC not cooling

Thermostat reading against likely cause. JavaScript is off, so the dial is shown as a table.
Reading	Likely cause	Urgency
60 F	The heating side is not producing heat at all. Ignition lockout, a dirty flame sensor or a tripped limit switch.	Call now
62 F	The burner is lighting then dropping out, or the blower is running without heat behind it.	Call now
64 F	A heat pump that is not completing the switch into heating mode, or one stuck relying on auxiliary resistance heat.	Call now
66 F	Heat is being produced but not distributed. Airflow restriction, duct losses or a zoning fault.	Call today
68 F	Close to a normal winter setpoint. If the room feels colder than this reading, suspect the thermostat itself.	Call today
70 F	Within the normal comfort band. Nothing here points at a fault on its own.	Monitor
72 F	Within the normal comfort band. Worth noting how long the system runs to hold this figure.	Monitor
74 F	Slightly above a typical cooling setpoint. If the system cycles on and off rapidly, that is the fault to chase.	Monitor
76 F	The system is falling behind setpoint. Airflow restriction or a coil that cannot absorb heat.	Call today
78 F	Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.	Call today
80 F	Supply air is close to room temperature. The refrigerant side or the compressor is not contributing.	Call today
82 F	Well above setpoint with the system running. Check for ice on the indoor coil or the line set.	Call now
84 F	Substantial capacity loss. A leak that has been developing across the season is the usual finding.	Call now
86 F	The system is effectively not cooling. Check whether the outdoor unit is running at all or tripping its breaker.	Call now
88 F	Indoor temperature is approaching outdoor temperature, which means no useful cooling is happening.	Call now
90 F	A health risk in a heat event. Move anyone vulnerable to a cooler space and treat this as urgent.	Call now

Residential street in Knoxville, Tennessee

What to do while you wait

Set the system to off instead of raising the setpoint, which will not force it to run.
Check whether the outdoor unit on a heat pump is iced over, and do not chip at it.
Look at the filter and replace it if light will not pass through.
Never heat a room with a gas range or an outdoor appliance. That is a carbon monoxide risk.

Nearby

Nearby cities we cover

Problems we route in Knoxville

ZIP codes with their own page

If you smell gas, none of this applies. Leave the building, call the gas utility or 911 from outside, and address the heating fault afterwards once the property has been made safe.

Emergency

If this is happening right now

Call now

No cool air during a heat advisory
No heat with outdoor temperatures below freezing
Burning smell from the vents
Water pooling at the air handler
Ice on the line set
Breaker tripping on every cycle

Call (855) 321-3194 and give your ZIP code.

Shut it off and call the utility or 911 first

You smell gas: leave the building, then call the gas utility or 911
Smoke or sparking at the equipment
A carbon monoxide alarm is sounding: leave and call 911

Reference: CPSC recalls and US Fire Administration heating fire safety.

Shut it down safely

Set the thermostat to off so the system stops cycling.
Kill the breaker at the air handler and at the outdoor condenser.
If you smell gas, leave the building first, then close the gas shut-off at the furnace only once you are outside and have called the utility or 911.
Clear the area around the equipment and keep pets and people away from it.

A 24/7 line means the phone is answered around the clock in ET. It does not mean a technician is standing by in every market at every hour.

Same-day and 24/7 emergency services are subject to provider participation, location, technician availability, and demand. Availability is not guaranteed and may vary by market and appointment capacity.

Call (855) 321-3194

Questions

Knoxville HVAC questions

Is there a charge to call?

No. There is no charge to call and no obligation to proceed. We may be compensated by providers or partners when you call, which does not affect what you pay. The provider quotes their own price before any work starts.

What heating systems do you cover in Knoxville?

Gas and electric furnaces, boilers, heat pumps running in heating mode, and the controls that operate them. Mention which you have when you call, because combustion work and refrigerant-cycle work need different parts on the truck.

Why is my heat pump running constantly?

A heat pump that never cycles off is usually low on charge, iced on the outdoor coil, or leaning on auxiliary resistance heat because the reversing valve is not completing the switch into heating mode.

Do I have to be home?

Yes. The technician needs access to the thermostat and the equipment itself, and someone has to approve the quoted price before work begins. For combustion appliances they may also want to check alarms.

What does heating repair cost in Knoxville?

We do not quote prices. The provider who attends confirms the price on site before work begins. Boiler and heat pump work generally takes longer to diagnose than a straightforward furnace fault.

Written and fact-checked by the HVAC Emergency USA editorial team. Last updated 10 October 2026. Editorial policy.