Emergency line open 24/7 · Times shown in ET

Heating repair in Richmond, VA

Richmond sits in City of Richmond County and we cover 39 ZIP codes across it. Furnace, boiler and heat pump faults route to an independent local provider.

Your call connects you with an independent local HVAC provider. No obligation.

Call (855) 321-3194

Answer

How do I get heating repair in Richmond, VA today?

Use (855) 321-3194. The operator takes your Richmond ZIP code and connects you with a heating provider covering it. Pricing is set by that provider and confirmed with you on site before any work is carried out.

Heating calls in Richmond

Richmond heating calls come through the same number as cooling calls. We publish both because the equipment, the failure modes and the urgency are different enough that they warrant separate pages.

Within Richmond we publish 39 ZIP codes for heating work. Nearby markets including Henrico, Fredericksburg, Newport News are listed separately with their own coverage.

Local considerations

Mixed winters where heat pumps and gas furnaces both appear, often in adjacent neighbourhoods. A heating system with deferred maintenance in Richmond is more likely to fail during the first genuinely cold stretch, because cold is what moves marginal components over the threshold.

A furnace that has sat idle through the Richmond cooling season accumulates dust on the flame sensor. The resulting lockout after three ignition attempts reads like a failure but is far more often a cleaning job.

Looking for the other side of the system? AC Repair in Richmond, VA.

CityRichmond

CountyCity of Richmond

StateVirginia

ZIPs covered39

Other vertical

AC Repair in Richmond, VA

Services

Heating services in Richmond

The heating services below cover most Richmond calls. The figures shown are national bands; major-tier costs for this market are listed further down.

6 services

Furnace Repair in Richmond

A furnace that ran fine last winter can lock out at the start of this one simply because the flame sensor accumulated enough summer dust to fail the safety check.

View furnace repair

Furnace Installation and Replacement service

Furnace Installation and Replacement in Richmond

Rising fuel bills combined with longer run times are the quiet signal that a furnace is losing efficiency and the replacement clock is running.

Details

Heat Pump Repair in Richmond

A heat pump that runs constantly without warming the house is usually leaning on auxiliary resistance because the compressor side is not contributing.

Details

Boiler Repair in Richmond

Pressure that drops overnight means there is a leak somewhere in the loop, and finding it before the pipes freeze is a different category of urgency than a summer repair.

Details

Thermostat Installation and Repair service

Thermostat Installation and Repair in Richmond

A thermostat stuck in cooling mode will not call for heat regardless of what the room temperature drops to.

Details

HVAC Maintenance and Tune-Up in Richmond

A tune-up before the heating season catches the igniter that is weakening, the limit switch that is drifting and the filter that is already loaded.

Details

Interactive

What is your thermostat reading?

Drag the dial to the temperature your thermostat shows now. The readout names the likely cause band, how urgent it is, and which page to read next.

Degrees F

Indoor temperature

Likely cause band: Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.
Urgency: Call today
Read next: AC not cooling

Thermostat reading against likely cause. JavaScript is off, so the dial is shown as a table.
Reading	Likely cause	Urgency
60 F	The heating side is not producing heat at all. Ignition lockout, a dirty flame sensor or a tripped limit switch.	Call now
62 F	The burner is lighting then dropping out, or the blower is running without heat behind it.	Call now
64 F	A heat pump that is not completing the switch into heating mode, or one stuck relying on auxiliary resistance heat.	Call now
66 F	Heat is being produced but not distributed. Airflow restriction, duct losses or a zoning fault.	Call today
68 F	Close to a normal winter setpoint. If the room feels colder than this reading, suspect the thermostat itself.	Call today
70 F	Within the normal comfort band. Nothing here points at a fault on its own.	Monitor
72 F	Within the normal comfort band. Worth noting how long the system runs to hold this figure.	Monitor
74 F	Slightly above a typical cooling setpoint. If the system cycles on and off rapidly, that is the fault to chase.	Monitor
76 F	The system is falling behind setpoint. Airflow restriction or a coil that cannot absorb heat.	Call today
78 F	Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.	Call today
80 F	Supply air is close to room temperature. The refrigerant side or the compressor is not contributing.	Call today
82 F	Well above setpoint with the system running. Check for ice on the indoor coil or the line set.	Call now
84 F	Substantial capacity loss. A leak that has been developing across the season is the usual finding.	Call now
86 F	The system is effectively not cooling. Check whether the outdoor unit is running at all or tripping its breaker.	Call now
88 F	Indoor temperature is approaching outdoor temperature, which means no useful cooling is happening.	Call now
90 F	A health risk in a heat event. Move anyone vulnerable to a cooler space and treat this as urgent.	Call now

Residential street in Richmond, Virginia

What to do while you wait

Turn the heating off at the thermostat and note how many times it tried to light.
If a carbon monoxide alarm is sounding, leave the building and call 911 from outside.
Change a loaded filter before the technician arrives, ruling out the simplest cause.
Move anyone vulnerable to the warmest room and add layers rather than using an open flame.

Nearby

Nearby cities we cover

Problems we route in Richmond

ZIP codes with their own page

A heating failure in Richmond is a timing problem as much as a repair problem. The sooner the call goes in, the more of the local provider capacity is still uncommitted.

Emergency

If this is happening right now

Call now

No cool air during a heat advisory
No heat with outdoor temperatures below freezing
Burning smell from the vents
Water pooling at the air handler
Ice on the line set
Breaker tripping on every cycle

Call (855) 321-3194 and give your ZIP code.

Shut it off and call the utility or 911 first

You smell gas: leave the building, then call the gas utility or 911
Smoke or sparking at the equipment
A carbon monoxide alarm is sounding: leave and call 911

Reference: CPSC recalls and US Fire Administration heating fire safety.

Shut it down safely

Set the thermostat to off so the system stops cycling.
Kill the breaker at the air handler and at the outdoor condenser.
If you smell gas, leave the building first, then close the gas shut-off at the furnace only once you are outside and have called the utility or 911.
Clear the area around the equipment and keep pets and people away from it.

A 24/7 line means the phone is answered around the clock in ET. It does not mean a technician is standing by in every market at every hour.

Same-day and 24/7 emergency services are subject to provider participation, location, technician availability, and demand. Availability is not guaranteed and may vary by market and appointment capacity.

Call (855) 321-3194

Questions

Richmond HVAC questions

Can someone come out tonight?

The line is answered 24/7 in ET. Whether a provider can reach Richmond overnight depends on participation, technician availability and demand, which spikes during cold snaps. The operator tells you the realistic window rather than guessing.

Is there a charge to call?

No. There is no charge to call and no obligation to proceed. We may be compensated by providers or partners when you call, which does not affect what you pay. The provider quotes their own price before any work starts.

What heating systems do you cover in Richmond?

Gas and electric furnaces, boilers, heat pumps running in heating mode, and the controls that operate them. Mention which you have when you call, because combustion work and refrigerant-cycle work need different parts on the truck.

Why is my heat pump running constantly?

A heat pump that never cycles off is usually low on charge, iced on the outdoor coil, or leaning on auxiliary resistance heat because the reversing valve is not completing the switch into heating mode.

Do I have to be home?

Yes. The technician needs access to the thermostat and the equipment itself, and someone has to approve the quoted price before work begins. For combustion appliances they may also want to check alarms.

Written and fact-checked by the HVAC Emergency USA editorial team. Last updated 10 October 2026. Editorial policy.