Emergency line open 24/7 · Times shown in ET

Heating repair in Spokane, WA

Spokane sits in Spokane County and we cover 28 ZIP codes across it. Furnace, boiler and heat pump faults route to an independent local provider.

Your call connects you with an independent local HVAC provider. No obligation.

Call (855) 321-3194

Answer

How do I get heating repair in Spokane, WA today?

Dial (855) 321-3194 and say which Spokane ZIP code you are in, and what type of system you have. We connect you with a provider covering that area. They confirm the visit window and quote their own price.

Heating calls in Spokane

When the heat stops in Spokane, the sequence matters. Turning the system off before calling prevents repeated failed ignition cycles, which do not fix anything and occasionally cause additional problems.

We list 28 ZIP codes for Spokane. Heating providers in Spokane County vary in which equipment types they take, so the ZIP code and the system type together decide the match.

Local considerations

Damp cool winters suit heat pumps, which run long low-output cycles rather than short hard ones. For Spokane that means the first genuinely cold night of the season produces a cluster of calls from systems that were fine in October.

Pipe insulation in Spokane is most valuable in runs that travel through unconditioned space: crawlspaces, unheated garages and exterior wall cavities. Those runs freeze first and they freeze fast when the heat source fails.

Looking for the other side of the system? AC Repair in Spokane, WA.

CitySpokane

CountySpokane

StateWashington

ZIPs covered28

Other vertical

AC Repair in Spokane, WA

Services

Heating services in Spokane

Heating work across Spokane concentrates in the categories below, spanning forced air, hydronic and heat pump equipment.

6 services

Furnace Repair in Spokane

Freeze risk makes a furnace failure urgent rather than inconvenient, and a burner that has sat idle all summer fouls its flame sensor before the first cold snap.

View furnace repair

Furnace Installation and Replacement service

Furnace Installation and Replacement in Spokane

Rising fuel bills combined with longer run times are the quiet signal that a furnace is losing efficiency and the replacement clock is running.

Details

Heat Pump Repair in Spokane

Defrost cycles that seem to run too often or not at all point at the defrost control board, which is a straightforward replacement once confirmed.

Details

Boiler Repair in Spokane

A boiler losing pressure in midwinter risks frozen pipes as well as cold rooms, so it moves to the front of the queue.

Details

Thermostat Installation and Repair service

Thermostat Installation and Repair in Spokane

A control reading the room temperature accurately is the foundation of any heating system. A one-degree error compounds across a whole heating season.

Details

HVAC Maintenance and Tune-Up in Spokane

An autumn tune-up cleans the flame sensor and checks the heat exchanger before the burner is asked to run every night.

Details

Interactive

What is your thermostat reading?

Drag the dial to the temperature your thermostat shows now. The readout names the likely cause band, how urgent it is, and which page to read next.

Degrees F

Indoor temperature

Likely cause band: Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.
Urgency: Call today
Read next: AC not cooling

Thermostat reading against likely cause. JavaScript is off, so the dial is shown as a table.
Reading	Likely cause	Urgency
60 F	The heating side is not producing heat at all. Ignition lockout, a dirty flame sensor or a tripped limit switch.	Call now
62 F	The burner is lighting then dropping out, or the blower is running without heat behind it.	Call now
64 F	A heat pump that is not completing the switch into heating mode, or one stuck relying on auxiliary resistance heat.	Call now
66 F	Heat is being produced but not distributed. Airflow restriction, duct losses or a zoning fault.	Call today
68 F	Close to a normal winter setpoint. If the room feels colder than this reading, suspect the thermostat itself.	Call today
70 F	Within the normal comfort band. Nothing here points at a fault on its own.	Monitor
72 F	Within the normal comfort band. Worth noting how long the system runs to hold this figure.	Monitor
74 F	Slightly above a typical cooling setpoint. If the system cycles on and off rapidly, that is the fault to chase.	Monitor
76 F	The system is falling behind setpoint. Airflow restriction or a coil that cannot absorb heat.	Call today
78 F	Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.	Call today
80 F	Supply air is close to room temperature. The refrigerant side or the compressor is not contributing.	Call today
82 F	Well above setpoint with the system running. Check for ice on the indoor coil or the line set.	Call now
84 F	Substantial capacity loss. A leak that has been developing across the season is the usual finding.	Call now
86 F	The system is effectively not cooling. Check whether the outdoor unit is running at all or tripping its breaker.	Call now
88 F	Indoor temperature is approaching outdoor temperature, which means no useful cooling is happening.	Call now
90 F	A health risk in a heat event. Move anyone vulnerable to a cooler space and treat this as urgent.	Call now

Residential street in Spokane, Washington

What to do while you wait

Set the thermostat to off rather than leaving it calling for heat against a locked-out system.
If you smell gas, leave the building first and call the gas utility or 911 from outside.
Replace a loaded filter. Restricted airflow trips high-limit switches on furnaces.
Close off unused rooms and keep anyone vulnerable in the warmest part of the house.

Nearby

Nearby cities we cover

Problems we route in Spokane

Set the thermostat to off rather than leaving it calling for heat against a locked-out system, then call. Repeated failed ignition cycles do no good and occasionally do harm.

Emergency

If this is happening right now

Call now

No cool air during a heat advisory
No heat with outdoor temperatures below freezing
Burning smell from the vents
Water pooling at the air handler
Ice on the line set
Breaker tripping on every cycle

Call (855) 321-3194 and give your ZIP code.

Shut it off and call the utility or 911 first

You smell gas: leave the building, then call the gas utility or 911
Smoke or sparking at the equipment
A carbon monoxide alarm is sounding: leave and call 911

Reference: CPSC recalls and US Fire Administration heating fire safety.

Shut it down safely

Set the thermostat to off so the system stops cycling.
Kill the breaker at the air handler and at the outdoor condenser.
If you smell gas, leave the building first, then close the gas shut-off at the furnace only once you are outside and have called the utility or 911.
Clear the area around the equipment and keep pets and people away from it.

A 24/7 line means the phone is answered around the clock in ET. It does not mean a technician is standing by in every market at every hour.

Same-day and 24/7 emergency services are subject to provider participation, location, technician availability, and demand. Availability is not guaranteed and may vary by market and appointment capacity.

Call (855) 321-3194

Questions

Spokane HVAC questions

What heating systems do you cover in Spokane?

Gas and electric furnaces, boilers, heat pumps running in heating mode, and the controls that operate them. Mention which you have when you call, because combustion work and refrigerant-cycle work need different parts on the truck.

Why is my heat pump running constantly?

A heat pump that never cycles off is usually low on charge, iced on the outdoor coil, or leaning on auxiliary resistance heat because the reversing valve is not completing the switch into heating mode.

Do I have to be home?

Yes. The technician needs access to the thermostat and the equipment itself, and someone has to approve the quoted price before work begins. For combustion appliances they may also want to check alarms.

What does heating repair cost in Spokane?

We do not quote prices. The provider who attends confirms the price on site before work begins. Boiler and heat pump work generally takes longer to diagnose than a straightforward furnace fault.

What should I do before the provider arrives?

Set the thermostat to off rather than leaving it calling for heat against a locked-out system, replace a loaded filter, and close off unused rooms. Keep anyone vulnerable in the warmest part of the house.

Written and fact-checked by the HVAC Emergency USA editorial team. Last updated 10 October 2026. Editorial policy.