Emergency line open 24/7 · Times shown in ET
Heating repair in Manhattan, KS
Manhattan sits in Riley County and we cover 4 ZIP codes across it. Furnace, boiler and heat pump faults route to an independent local provider.
Your call connects you with an independent local HVAC provider. No obligation.
Call (855) 321-3194How do I get heating repair in Manhattan, KS today?
Dial (855) 321-3194 and say which Manhattan ZIP code you are in, and what type of system you have. We connect you with a provider covering that area. They confirm the visit window and quote their own price.
Heating calls in Manhattan
When the heat stops in Manhattan, the sequence matters. Turning the system off before calling prevents repeated failed ignition cycles, which do not fix anything and occasionally cause additional problems.
Within Manhattan we publish 4 ZIP codes for heating work. Nearby markets including Abilene, Allen, Admire are listed separately with their own coverage.
Local considerations
Zone thermostats in Manhattan multi-zone systems can fail independently without stopping the boiler or furnace. A zone that reads the setpoint but never opens its valve is a thermostat or valve problem, not an equipment problem.
Duct losses on the heating side in Manhattan are easy to overlook because they do not cause a fault code. A forced-air system losing output to duct leakage in unconditioned space shows up as a comfort complaint, not a breakdown.
Looking for the other side of the system? AC Repair in Manhattan, KS.
Other vertical
Services
Heating services in Manhattan
These are the heating services most often requested from Manhattan. Each page sets out the symptoms, the parts that usually fail and the typical cost band.
6 services
Furnace Repair in Manhattan
Freeze risk makes a furnace failure urgent rather than inconvenient, and a burner that has sat idle all summer fouls its flame sensor before the first cold snap.
View furnace repair
02 Furnace Installation and Replacement in Manhattan
Rising fuel bills combined with longer run times are the quiet signal that a furnace is losing efficiency and the replacement clock is running.
Details
03 Heat Pump Repair in Manhattan
Defrost cycles that seem to run too often or not at all point at the defrost control board, which is a straightforward replacement once confirmed.
Details
04 Boiler Repair in Manhattan
A boiler losing pressure in midwinter risks frozen pipes as well as cold rooms, so it moves to the front of the queue.
Details
05 Thermostat Installation and Repair in Manhattan
A control that will not switch into heating mode leaves the house cold while the equipment itself is perfectly serviceable.
Details
06 HVAC Maintenance and Tune-Up in Manhattan
Heat exchanger inspection during a tune-up is the one check that cannot wait until a fault appears, because cracks create carbon monoxide risk before the system stops heating.
DetailsInteractive
What is your thermostat reading?
Drag the dial to the temperature your thermostat shows now. The readout names the likely cause band, how urgent it is, and which page to read next.
78
Degrees F
- Likely cause band
- Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.
- Urgency
- Call today
- Read next
- AC not cooling
What to do while you wait
- Set the thermostat to off rather than leaving it calling for heat against a locked-out system.
- If you smell gas, leave the building first and call the gas utility or 911 from outside.
- Replace a loaded filter. Restricted airflow trips high-limit switches on furnaces.
- Close off unused rooms and keep anyone vulnerable in the warmest part of the house.
Nearby
Nearby cities we cover
Problems we route in Manhattan
Cold snaps in Riley County generate more calls than the local provider network can absorb at once. The operator tells you honestly what the window looks like rather than booking one nobody can meet.
Emergency
If this is happening right now
Call now
- No cool air during a heat advisory
- No heat with outdoor temperatures below freezing
- Burning smell from the vents
- Water pooling at the air handler
- Ice on the line set
- Breaker tripping on every cycle
Call (855) 321-3194 and give your ZIP code.
Shut it off and call the utility or 911 first
- You smell gas: leave the building, then call the gas utility or 911
- Smoke or sparking at the equipment
- A carbon monoxide alarm is sounding: leave and call 911
Reference: CPSC recalls and US Fire Administration heating fire safety.
Shut it down safely
- Set the thermostat to off so the system stops cycling.
- Kill the breaker at the air handler and at the outdoor condenser.
- If you smell gas, leave the building first, then close the gas shut-off at the furnace only once you are outside and have called the utility or 911.
- Clear the area around the equipment and keep pets and people away from it.
A 24/7 line means the phone is answered around the clock in ET. It does not mean a technician is standing by in every market at every hour.
Same-day and 24/7 emergency services are subject to provider participation, location, technician availability, and demand. Availability is not guaranteed and may vary by market and appointment capacity.
Call (855) 321-3194Questions
Manhattan HVAC questions
What heating systems do you cover in Manhattan?
Gas and electric furnaces, boilers, heat pumps running in heating mode, and the controls that operate them. Mention which you have when you call, because combustion work and refrigerant-cycle work need different parts on the truck.
Why is my heat pump running constantly?
A heat pump that never cycles off is usually low on charge, iced on the outdoor coil, or leaning on auxiliary resistance heat because the reversing valve is not completing the switch into heating mode.
Do I have to be home?
Yes. The technician needs access to the thermostat and the equipment itself, and someone has to approve the quoted price before work begins. For combustion appliances they may also want to check alarms.
What does heating repair cost in Manhattan?
We do not quote prices. The provider who attends confirms the price on site before work begins. Boiler and heat pump work generally takes longer to diagnose than a straightforward furnace fault.
What should I do before the provider arrives?
Set the thermostat to off rather than leaving it calling for heat against a locked-out system, replace a loaded filter, and close off unused rooms. Keep anyone vulnerable in the warmest part of the house.
Written and fact-checked by the HVAC Emergency USA editorial team. Last updated . Editorial policy.