Emergency line open 24/7 · Times shown in ET

Heating repair in Butte, MT

Butte sits in Silver Bow County and we cover 2 ZIP codes across it. Furnace, boiler and heat pump faults route to an independent local provider.

Your call connects you with an independent local HVAC provider. No obligation.

Call (855) 321-3194

Answer

How do I get heating repair in Butte, MT today?

Call (855) 321-3194. Your Butte ZIP code decides which providers can be offered to you across Silver Bow County. The provider confirms the appointment and the price before any work begins.

Heating calls in Butte

Heating failures in Butte are more time-sensitive than cooling faults, because a house loses temperature faster than it gains it. We cover 2 ZIP codes across Silver Bow County for furnace, boiler and heat pump faults.

All 2 ZIP codes shown sit within Butte, Silver Bow County. During a freeze event the ZIP code matters more than usual, because travel time decides who can realistically reach you.

Local considerations

Zone valve and baseboard issues in older Butte hydronic systems often get misdiagnosed as boiler faults. If some rooms are warm and others are not, the heat source may be working correctly and the distribution is not.

Carbon monoxide risk applies to any combustion appliance in a Butte home. A working alarm near sleeping areas is the only reliable warning, and a sounding alarm means leaving the building before calling anyone.

Looking for the other side of the system? AC Repair in Butte, MT.

CityButte

CountySilver Bow

StateMontana

ZIPs covered2

Other vertical

AC Repair in Butte, MT

Services

Heating services in Butte

These are the heating services most often requested from Butte. Each page sets out the symptoms, the parts that usually fail and the typical cost band.

6 services

Furnace Repair in Butte

Freeze risk makes a furnace failure urgent rather than inconvenient, and a burner that has sat idle all summer fouls its flame sensor before the first cold snap.

View furnace repair

Furnace Installation and Replacement service

Furnace Installation and Replacement in Butte

Rising fuel bills combined with longer run times are the quiet signal that a furnace is losing efficiency and the replacement clock is running.

Details

Heat Pump Repair in Butte

Defrost cycles that seem to run too often or not at all point at the defrost control board, which is a straightforward replacement once confirmed.

Details

Boiler Repair in Butte

Kettling noise means scale on the heat exchanger, and left unaddressed it reduces efficiency and eventually causes cracking.

Details

Thermostat Installation and Repair service

Thermostat Installation and Repair in Butte

Short cycling in heating mode stresses the heat exchanger through repeated thermal shock, making thermostat problems worth addressing promptly.

Details

HVAC Maintenance and Tune-Up in Butte

Flame sensor cleaning in October prevents the lockout that owners discover in January when the furnace refuses to light on a cold morning.

Details

Interactive

What is your thermostat reading?

Drag the dial to the temperature your thermostat shows now. The readout names the likely cause band, how urgent it is, and which page to read next.

Degrees F

Indoor temperature

Likely cause band: Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.
Urgency: Call today
Read next: AC not cooling

Thermostat reading against likely cause. JavaScript is off, so the dial is shown as a table.
Reading	Likely cause	Urgency
60 F	The heating side is not producing heat at all. Ignition lockout, a dirty flame sensor or a tripped limit switch.	Call now
62 F	The burner is lighting then dropping out, or the blower is running without heat behind it.	Call now
64 F	A heat pump that is not completing the switch into heating mode, or one stuck relying on auxiliary resistance heat.	Call now
66 F	Heat is being produced but not distributed. Airflow restriction, duct losses or a zoning fault.	Call today
68 F	Close to a normal winter setpoint. If the room feels colder than this reading, suspect the thermostat itself.	Call today
70 F	Within the normal comfort band. Nothing here points at a fault on its own.	Monitor
72 F	Within the normal comfort band. Worth noting how long the system runs to hold this figure.	Monitor
74 F	Slightly above a typical cooling setpoint. If the system cycles on and off rapidly, that is the fault to chase.	Monitor
76 F	The system is falling behind setpoint. Airflow restriction or a coil that cannot absorb heat.	Call today
78 F	Cooling capacity loss: dirty coil, low refrigerant charge from a leak, or a failing capacitor.	Call today
80 F	Supply air is close to room temperature. The refrigerant side or the compressor is not contributing.	Call today
82 F	Well above setpoint with the system running. Check for ice on the indoor coil or the line set.	Call now
84 F	Substantial capacity loss. A leak that has been developing across the season is the usual finding.	Call now
86 F	The system is effectively not cooling. Check whether the outdoor unit is running at all or tripping its breaker.	Call now
88 F	Indoor temperature is approaching outdoor temperature, which means no useful cooling is happening.	Call now
90 F	A health risk in a heat event. Move anyone vulnerable to a cooler space and treat this as urgent.	Call now

What to do while you wait

Set the system to off instead of raising the setpoint, which will not force it to run.
Check whether the outdoor unit on a heat pump is iced over, and do not chip at it.
Look at the filter and replace it if light will not pass through.
Never heat a room with a gas range or an outdoor appliance. That is a carbon monoxide risk.

Nearby

Nearby cities we cover

Problems we route in Butte

If you smell gas, none of this applies. Leave the building, call the gas utility or 911 from outside, and address the heating fault afterwards once the property has been made safe.

Emergency

If this is happening right now

Call now

No cool air during a heat advisory
No heat with outdoor temperatures below freezing
Burning smell from the vents
Water pooling at the air handler
Ice on the line set
Breaker tripping on every cycle

Call (855) 321-3194 and give your ZIP code.

Shut it off and call the utility or 911 first

You smell gas: leave the building, then call the gas utility or 911
Smoke or sparking at the equipment
A carbon monoxide alarm is sounding: leave and call 911

Reference: CPSC recalls and US Fire Administration heating fire safety.

Shut it down safely

Set the thermostat to off so the system stops cycling.
Kill the breaker at the air handler and at the outdoor condenser.
If you smell gas, leave the building first, then close the gas shut-off at the furnace only once you are outside and have called the utility or 911.
Clear the area around the equipment and keep pets and people away from it.

A 24/7 line means the phone is answered around the clock in ET. It does not mean a technician is standing by in every market at every hour.

Same-day and 24/7 emergency services are subject to provider participation, location, technician availability, and demand. Availability is not guaranteed and may vary by market and appointment capacity.

Call (855) 321-3194

Questions

Butte HVAC questions

What does heating repair cost in Butte?

We do not quote prices. The provider who attends confirms the price on site before work begins. Boiler and heat pump work generally takes longer to diagnose than a straightforward furnace fault.

What should I do before the provider arrives?

Set the thermostat to off rather than leaving it calling for heat against a locked-out system, replace a loaded filter, and close off unused rooms. Keep anyone vulnerable in the warmest part of the house.

What if my furnace is still under warranty?

Parts warranties of five to ten years are common, labor warranties are not. Have the model and serial number ready when you call so the provider can check coverage before fitting anything.

My furnace locks out after three tries. What is that?

Three failed ignition attempts followed by a lockout usually means the flame sensor is dirty, the igniter is weak or gas pressure is wrong. After a long idle summer, cleaning resolves it more often than replacing parts does.

Is a cracked heat exchanger repairable?

No. A cracked heat exchanger is a carbon monoxide risk rather than a comfort fault, and the correct response is replacement of the furnace. Any provider suggesting a patch on one is giving you poor advice.

Written and fact-checked by the HVAC Emergency USA editorial team. Last updated 10 October 2026. Editorial policy.